Wisycom Manager

MRK16:
Updated specific alarms.
Added support for scan frequencies and predefined scan ranges.
Added support for EXP3 board.
MRK980:
Updated specific alarms.
MTP60:
Updated specific alarms.
Updated settings layout according to firmware v1.6.0
MCR42:
Added 100ms of delay on compander selection command
MCR42, MPR52-ENG, MPR51-ENG:
Added support for 8/16 bit transmitter battery.
MTP30/MTH300
Fixed device recognition problem.
General devices:
Added minimum suggested bootloader for device
Added signaling if connected device has bootloader version less than minimum suggested.
Monitoring Area bug fix:
When mouse button is clicked over a control previous selections are cleared and new control is selected and contex menu is shown.
Frequencies Calculator:
Added Linear to protection level options.
Added modulation selection.

• Added compatibility with MRK16, MTP60, MCR54-DUAL
• Added Bulk Edit Function on MTK952
  This function allow to select multiple MTK952 the same time and perform some actions on all them simultaneously such as switching ON/OFF the RF power, selecting the RF PWR level, M/S configuration and more. To perform this simply select the units from the monitoring windows and then right click on any of the selected ones.
• Fixed several minor bugs on the following units:
  – MPA221
  – MFL
  – MFLC
  – MRK980
  – MAT2xx
• Improved remote control function from multiple PCs
  NOTE: Remote control function is available for the following devices:
  – MAT288
  – MAT244
  – MFL
  – MTK952
  – MRK980
  – SPL2208
  – SPL2216
  NOTE: it must be enabled remote control on the Tools > Options > REMOTE CONTROL menu

Please uninstall the previous version of Wisycom Manager you have in your PC before install v3.2.5

Added:
– IRDA bridge feature for remote control of Wisycom Transmitters by Wisycom Manager equal or higher v3.1.0
– Channel SCAN command for compatibility with Sound Device SL-2
– 8/16-bit telemetry decoding
– Improved multiple frequency set up after a Channel SCAN
– Improved shutdown sequence
– OFF timeout display unit changed from minutes to seconds
– Squelch mode OFF removed
– USER mode Noise squelch range reduced to 8-25 dB
– In the main overview display RF Squelch level replaced with Squelch mode

Bug Fix:
– Calibration tone issue
– Graphic artifact after the Freq. SCAN
– Generic minor graphic issues
– Serial Communication stall when incoming data have baud rate different from 115200

added compatibility with
– MCR54
– RPU500
– BX3 power box for fiber link
– MCR41 (partial)

SUPPORTED DEVICES

added remote control of the following devices:
– MAT288
– MAT244
– MFL
– MTK952
– MRK980
– SPL2208
– SPL2216

NOTE: it must be enabled remote control on the Tools > Options > REMOTE CONTROL menu

• SPL2208/SPL2216:
  • fixed problem during the closing of settings page
• ADFA/LFA/BFA:
  • added command to read name of the filter
• MPR51/52:
  • added possibility to save Channel/Group on the Preset
• Devices with Ethernet interface[MAT288/MAT244]
  • added the possibility to modify Ethernet interface settings DHCP/STATIC